My Azeron Software just said I had to push a Firmware update to the Cyborg Keypad, after I did it stopped being detected by the software.
The software said the firmware update was successful, I rebooted everything to make sure it was all good and now the software just says "Select your Device" and no devices show (Image attached).
I've tried to do a reset with the recessed button underneath, when I do the light on the side goes out and never comes back on.
After disconnecting and reconnecting it I see the software says "Connect a device" then changes to "Select your Device" again.
This is my gaming pad and I really need it working again, whats going on?
The software said the firmware update was successful, I rebooted everything to make sure it was all good and now the software just says "Select your Device" and no devices show (Image attached).
I've tried to do a reset with the recessed button underneath, when I do the light on the side goes out and never comes back on.
After disconnecting and reconnecting it I see the software says "Connect a device" then changes to "Select your Device" again.
This is my gaming pad and I really need it working again, whats going on?