I recently started having stick drift issues on my Cyborg Compact. I've had it about 2 years, so this isn't a surprise. I started by removing the thumbstick board and cleaning the dust/debris, but it didn't do much. Looking at some of the posts here, I noticed similar issues, all wiring related.
While I had the board out, one of the wires broke at the soldered via. This happened to a couple other wires afterward, just from moving the board around. This wiring is relatively soft and delicate. It could use strain relief to protect the solder joints. Does anyone have a connector option that would fit?
If I could get a connector in, I'd be able to stick with the soft silicone. For now, my plan is to rewire with 22 ga pvc insulated instead. I'm also looking into ferrules for the terminal block end.
While I had the board out, one of the wires broke at the soldered via. This happened to a couple other wires afterward, just from moving the board around. This wiring is relatively soft and delicate. It could use strain relief to protect the solder joints. Does anyone have a connector option that would fit?
If I could get a connector in, I'd be able to stick with the soft silicone. For now, my plan is to rewire with 22 ga pvc insulated instead. I'm also looking into ferrules for the terminal block end.
