My Issue, as I have seen other complain about, is when you are gaming and many like myself press these keys like my life is depending on it. I tend to press them so hard at times it may actually move the button down a little and I find myself having to loosen the screws move the buttons back into place then retighten the screws underneath the button again. I tend to put a lot of pressure on the index finger the most and in turn the ball joint that holds that in place.
I was rather disappointed to see there was no upgrade to this on the cyborg 2 for the joints to keep the switches from sliding. Ill probably have to 3D print some wedges to go into the joints under the switches to keep them in place or I'm going to start to strip out the screws trying to tighten them to keep the switches from moving at all.
I would like to see in the future models down the road a way to more firmly hold the position of how I set up my Azeron so things are not moving around once I tighten it up.
I was rather disappointed to see there was no upgrade to this on the cyborg 2 for the joints to keep the switches from sliding. Ill probably have to 3D print some wedges to go into the joints under the switches to keep them in place or I'm going to start to strip out the screws trying to tighten them to keep the switches from moving at all.
I would like to see in the future models down the road a way to more firmly hold the position of how I set up my Azeron so things are not moving around once I tighten it up.
