Need help from a hardware engineer, after replacing the thumbstick it doesn't work properly, the software shows it always points diagonally up,

pengliang

New member
Apr 2, 2022
8
0
1
My cyborg got weird orientation movement after 4 months of use, today I replaced the thumbstick, it always points diagonally up, I guess it might be damaged, replaced the thumbstick again, no help, reset clear still no result , but the 5 direction stick is working normally, the picture is the line after my repair, does it look normal, or is it some other problem?
 

Attachments

  • azeron-support-help.txt
    728 bytes · Views: 15
  • IMG_20220924_192305.jpg
    IMG_20220924_192305.jpg
    1.9 MB · Views: 24
  • IMG_20220924_192358.jpg
    IMG_20220924_192358.jpg
    1.8 MB · Views: 24
  • IMG_20220924_192419.jpg
    IMG_20220924_192419.jpg
    1.6 MB · Views: 24
  • 360截图20220924194228990.jpg
    360截图20220924194228990.jpg
    59.9 KB · Views: 26
  • 360截图20220924200709675.jpg
    360截图20220924200709675.jpg
    53.2 KB · Views: 28

AZGUNS

Active member
Apr 22, 2022
166
64
28
My cyborg got weird orientation movement after 4 months of use, today I replaced the thumbstick, it always points diagonally up, I guess it might be damaged, replaced the thumbstick again, no help, reset clear still no result , but the 5 direction stick is working normally, the picture is the line after my repair, does it look normal, or is it some other problem?
Check to see if any wires are loose on the Teensy Board. you can find a wiring diagram here https://github.com/melaphor/trackzeron
 

pengliang

New member
Apr 2, 2022
8
0
1

Attachments

  • IMG_20220925_084341.jpg
    IMG_20220925_084341.jpg
    2 MB · Views: 18
  • IMG_20220925_084348.jpg
    IMG_20220925_084348.jpg
    2.2 MB · Views: 18
  • IMG_20220925_090638.jpg
    IMG_20220925_090638.jpg
    2.2 MB · Views: 19
  • 360截图20220925090730884.jpg
    360截图20220925090730884.jpg
    71.8 KB · Views: 18

Im this guy

Moderator
Staff member
Nov 5, 2021
400
64
28
Don't think the pot is broken since you swapped two. Might be that the board was overheated at some point, that would be my guess.