just unboxed cyborg , input and analog stick issues

vladstrar

New member
May 13, 2022
4
0
1
pre-purchased in 2021, but just now unboxed and tried to use. Have performed hardware reset and on latest firmware.
A) Cannot calibrate thumbstick, when i try to move it in a circle per calibration instructions it only show it moving in a upper left to middle diagonal line and gives an error of cant calibrate upper deadzone
B) two inputs are not working, they do not register on software even though I can feel keypress.
 

Im this guy

Moderator
Staff member
Nov 5, 2021
1,042
117
63
pre-purchased in 2021, but just now unboxed and tried to use. Have performed hardware reset and on latest firmware.
A) Cannot calibrate thumbstick, when i try to move it in a circle per calibration instructions it only show it moving in a upper left to middle diagonal line and gives an error of cant calibrate upper deadzone
B) two inputs are not working, they do not register on software even though I can feel keypress.
Sounds like wires are not getting signal.
Which buttons aren't working ? You can give numbers from Azeron software so I can provide you with diagram on which wires you would have to re-sit